SWAS removes all types of flux residues (RA, RMA, no-clean and water-soluble) quickly and efficiently, with minimal environmental effect using low cost, readily available cleaning equipment. It is ideally suited for the removal of very stubborn flux residues and no-clean fluxes, which can be extremely difficult to remove. SWAS will remove them to military cleanliness standards. It also has a lower odour than the other Safewash variants and is easy to rinse.
For removing flux from soldering and deposits left from water damage
Safe on brass, copper, aluminium and other sensitive metals
1 part concentrate to 10 parts of water
Temperature of bath should be set between 50 - 80 degrees centigrade
Available in 1L & 5L bottles
A specialist formulation for adding to Ultrasonic baths for removing flux from soldering and even deposits left from water damage
The cleaning process safely removes contaminants etc and will not damage, corrode or darken metal components
Safe on brass, copper, aluminium and other sensitive metals
Directions - Concentrate is added to water at a rate of 1 part concentrate to 10 parts water (we recommend using deionised / demineralised water)
Operating temperature of bath should be set between 50 - 80 degrees centigrade
After cleaning rinse all surfaces thoroughly with clean water
The bath should be changed regularly when the solution becomes dirty
Deep clean - Ideal for stain removal and removing dirt and oxidation
Safe to use on most metals, although please test before use
Cleaning all metals including brass, aluminium, copper, zinc, tin & alloys
Available in 1L & 5L bottles
It quickly removes grease, oil, lubricants and grime from surfaces and emulsifies them into the solution
The cleaning process will not damage, corrode or darken metal component
Safe on brass, aluminium and other sensitive metals
Directions - Concentrate is added to water at a rate of 1 part concentrate to 10 parts water (we recommend using deionised/demineralised water)
Operating temperature of the bath should be set between 50 - 80 degrees centigrade
After cleaning rinse all surfaces thoroughly with clean water
The bath should be changed regularly when the solution becomes dirty
Safe to use on most metals, although please test before use